CARE INSTRUCTIONS

To keep your heat-transferred designs looking fresh and prevent peeling or cracking, follow these standard care steps:

• Turn Inside Out: Always flip the garment inside out. This protects the transfer from rubbing against other clothes or the agitator.

• Use Cold Water: Set your machine to cold or cool water (below 90°F/30°C). High heat can reactivate the adhesive and cause the design to lift.
• Mild Detergent Only: Use a standard mild detergent. Avoid bleach, fabric softeners, or “green” detergents, as these can break down the vinyl or ink.
• Hang Dry (Preferred): Air drying is the safest method. if you must use a dryer, use the lowest heat setting or tumble dry low.
• Never Iron Directly: If the garment needs ironing, iron on the reverse side or place a piece of parchment paper over the design. Never touch a hot iron directly to the transfer
  

  Product Measurements

• Body Length at Back: Measured from high point shoulder to finished hem at back.
• Chest: Measured across the chest one inch below armhole when laid flat.
• Raglans and Dolmans Sleeve Length: Measure from neck edge to finished hem.

Size Chart